Tractor Talk Discussion Board |
Re: gee, my 8N ran great two weeks ago
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by chuck on January 31, 2000 at 09:29:39 from (152.163.197.194):
In Reply to: gee, my 8N ran great two weeks ago posted by Bill on January 29, 2000 at 21:45:55:
There are actually four basics required to start an engine; fuel, ignition, compression, TIMING. Timing isn't likely to be your problem, it's more a consideration with an engine that uses a timing chain or belt, most tractors use gears that rarely fail. It's a bad idea to squirt starting fluid into the intake manifold with out the carb on there, if the engine had started it would have revved up out of control until the fluid was burned up or the rods came out through the side of the block. The checks you've alraedy made seem to cover fuel and spark, assume so for now. What you should do now is what is refered to is baseline the engine, in simple terms check the compression of each cylinder. 100 psi in each cyl. would be exellent, anything less than 60psi won't fire. That is just a plain fact. If a compression test shows 60 or less under the present circumstances, then you might get it running by changing those circumstances. All that gas and starting fluid might have washed the oil off the cylinder walls, the weather might be colder and thick oil might cause a slower cranking speed, thus lower compression, colder temperatures also mean a weaker battery, also lower compression. So, if the comp. test is low, warm up the engines enviroment, or jump the battery with a 12volt source, or put some oil in the cyinders while you have the plugs out(spin the motor over before replacing the plugs to insure you didn't put too much in), try new plugs. If none of these things work for you, then rexamine the fuel and spark.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|