Posted by VADAVE on June 09, 2008 at 08:31:49 from (149.32.192.33):
In Reply to: raising large posts posted by StuBC on June 09, 2008 at 07:26:12:
Done this a few times--it isn't hard. There are two ways: 1) With the loader--like Mike says put a chain around it above the center of gravity so the butt is down, drive over the hole and lower it in. 2) Load the pole on a reuck with a dump bed, butt out the back. Place a plywood panel in hole on the far side. Back truck with pole to the hole and place butt against plywood in hole by raising truck bed. Pull forward slightly so butt stays in the hole, lower bed--the pole should now be above cab with the butt against plywood in hole. Back up smartly. The pole will go up as you approach the hole and will drop into same--do not back past the hole. If you back up too slow the pole will slide off side ways.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
