Posted by Spook on June 14, 2008 at 19:51:30 from (198.208.251.23):
In Reply to: Tiller Trouble posted by Joe MD on June 14, 2008 at 13:42:07:
That's a Troy - Built tiller, you need to adjust the block, so that the roller is held down farther to put more tension on the belt. When you run out of adjustment, you need a new belt. I have had mine for 20 years, adjusted it once right after I got it, and again this year. Probably next time, I need a belt? it's not hard to adjust, just loosen 1 bolt, and slide the block down, tighten the bolt. It will take some trial and error to get it right, but it is maybe a 20 minute job. A long screwdriver and a small hammer are handy to tap the block down. You shouldn't have to move it far, 1/8 of an inch or so.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
