Posted by JRT on June 14, 2008 at 20:59:38 from (68.238.117.48):
In Reply to: Best chainsaw?..who posted by gun guru on June 14, 2008 at 15:09:07:
I have three mid size saws. A jonsared, a dolmar, and a shandawa. They are all good saws but for equal size, the jonsared will outcut the others in any kind of wood. I have tried to kill it but cannot. Last winter, I cut a tree down on it and drove it in the ground about 3 inches but that was not enough. A week later I ran over it with the rear wheel of a tractor. Still that did not kill it. I just straightened it out and it keeps on sawing. I guess that when I do finally kill it that will be it because there is no jonsared dealerships close to me. It must be at least 15 years old. I would buy another one if a dealership was convenient.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
