Posted by Drew on June 27, 2008 at 18:16:15 from (12.210.63.123):
In Reply to: Re: C bearings posted by 36 coupe on June 27, 2008 at 15:50:32:
But they are not near as accurate! The best way to measure all this, and I realize it is a lot of $$ to get this equipment, are a set of mircometers and a dial bore guage.
It is real easy w/ a bore guage to go up and down and around the housing bore of the rod and see taper and out of roundness.
With this equipment, you dont even need plastiguage. If the crankpin is round and measures what it is supposed to, the housing bore/bearing surface of the rod is round and measures what is supposed to....bolt it together. NOTE: Set the bore guage w/ the same mic as you check the crankpin with.
I am a machinist and work on engine parts everyday. Dial calipers are more accurate than a scale (Steel rule), but if you need to measure a bore in a part and measure it right, dial calipers wont cut it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
