Posted by Walt davies on June 28, 2008 at 06:16:36 from (75.106.239.52):
In Reply to: Re: C bearings posted by Brian Jasper co. Ia on June 27, 2008 at 18:12:55:
I was trained in the Navy went school and all to be a machinist haven't worked much at it after that because the pay was horrible compared to other work. If your micrometer is set properly then using one or two or three won't make any difference if you know how to use them. We had a dispute about that in "A" school in the Navy, one of the teachers was telling us that no one can get the same reading on things with a Mic. another Chief and I disagreed with him so they setup a test we both measured things from a hair to paper to different metals and both of us came up with the same reading. Its all in knowing the feel of the mic to get it correct. I think that Lance may have an out of round journal or something that is causing the false reading. he needs to have an expert look at it for him. I use an old vernier scale caliper and get to within .0005 with no trouble although I need a glass now to read the vernier Old age ain't what its all cracked up to be. Walt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
