Posted by 36 coupe on June 29, 2008 at 05:54:47 from (64.136.26.226):
In Reply to: Re: Its over posted by Lanse on June 28, 2008 at 17:31:51:
You can make a wood grass board from ash or buy an all steel grass board.I still use rivets on the sections and sharpen with a 4 inch angle grinder.Just be careful setting the mower down or picking it up for transpost.In short keep your fingers away from the knives,wear gloves when taking the knife out for repairs or sharpening.Refer to a new knife section when sharpening,keeping the same angle.Replace bent or cracked sections.Find an old knife repair block.Old rivets are sheared off by striking the back edge of the section with a heavy hammer.Use a ball pein hammer to head over new rivets.Ive been using mowers for 50 years,still have all my fingers.Run that rusty knife for a few minutes and oil it before taking it out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.