Rick I needed one of the bolts that holds the starter rewind to the motor. The one that the throttle piviots on. I was able to make one using a bolt and some lock nuts so I got that solved. Another part was the PLATE,RETAINER-STARTER PAWL. This is the round plate the swing out pawls fit in. It was worn and the pawls were sticking behind it rather than swinging out. I had a friend build it back up and then grind to proper size. It works fine now. So I have the top end done. It starts on one or two pulls; idles and throttles up well so now I am going to move on to the lower section. I have found a complete water pump on the net but could not find a reseal kit for the lower end. I am in the process of putting one together piece by piece. While I do not have the lower end apart yet I can see that I have a little slack in the propeller. The backlash is a little to much it seems. So while I am replacing the water pump and resealing the lower end just for piece of mind I am affraid I may find some worn gears that are NLA in there. I have less than $100 in this motor as it sits and it runs well enough now to use as is; so I have some room to play with. I just want to make sure I can get all the parts I need before buying anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
