Posted by KEH on July 05, 2008 at 04:53:06 from (207.144.58.181):
Allan,
Another point about wheel rakes is transport width. The 10 wheel Vermeer I have is fairly wide in transport position. I noticed a new Hesston V rake which folded the whels into a much tighter position. However it has a narrow wheel spacing which I think would make it more likely to turn over when making turns on a hillside with the wheels raised or when transporting it on the road. Of course, you don't have hills there.
On a V rake you have to adjust the width of the windrow for different amounts of hay. One theory also is that the hay in the middle of the windrow is not disturbed and the baler will not pick it up because it has flattened down on the ground. Some rakes have an extra wheel in the front center to turn that hay. Haven't noticed that being a problem.
The inline rakes have the tongue swing over into transport position which makes for a narrow, but long transport width. Each wheel floats individually, neat for rough ground. As I said on my earlier post, combining 2 or more windrows is no problem. Gary said he had a 9 wheel and he could describe better an inline rake's operation.
In looking at used wheel rakes the first thing to check is the condition of the rake teeth. Compare the used teeth with a new one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
