Posted by Janicholson on August 18, 2008 at 18:02:13 from (66.173.50.66):
In Reply to: Help!!!!!!!!!!!!! posted by bAlatonmMN on August 18, 2008 at 10:19:03:
My best shot(from St Cloud) Cut three strips of 1/2" thick steel that will just fit between the valve springs where the three rocker stands are bolted down. Each should be long enough to go back to the rear of the head and rest on the rim of the valve cover rib, and long enough to cover the head bolt holes shown lining up with them. Drill a hole in each for a grade 8 bolt to screw well into the rocker stand holes shown in the pic. Put in three head bolts in those three holes, but do not tighten them, leave them 1/8" loose. Now put in the metal strips, and sequentially tighten the Grade 8 bolts. If it still will not budge, and with the force on it, I would drive old Cheap knives (Pawn shop stuff) into the head gasket to begin the fracture process along the port side of the head. Not the point, the flat part of the blade struck on the back edge. Good luck, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
