Posted by GA Dave on August 24, 2008 at 19:38:13 from (207.69.139.145):
In Reply to: home built posted by ken in texas on August 24, 2008 at 14:16:01:
About 1968 one of my buddies gave me a rolled 57 Chevy. I took the body off and went to a junkyard and bought a 41 Chevy truck cab that had the roll out windshield. Mounted it on the 57 frame and shortened the frame (including shortening the springs) untill the rear wheels were almost touching the cab. Very short driveshaft. Welded two wheels together using spacers with the center cut out of one and reversed where you mounted the tires from either side (four wheel drive on the rear axles). Finally welded the spider gears together for real four wheel drive on the back tires. We called it a "bush buggy" and it would go about anywhere with snow grips on the rear. The original six cylinder was good but my neighbor gave me a burned truck with a good 283 so I put it in. We had a lot of fun with it. Only broke one axle because of the welded spider gears. David..........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.