Posted by Floyd A tn on September 01, 2008 at 19:17:31 from (74.240.212.14):
In Reply to: PTO and Multi-Power posted by coyote55 on September 01, 2008 at 13:43:09:
thanks for the info, where is the screen located and can it be cleaned with out breaking the tractor in half, and how do you adjust the pto clutch[/quote:d8581cc966]
The screen for the multipower is accessed through the pto lever plate. When you remove the plate, feel toward the front of the trans and there should be two bolts holding a tube that goes down to the screen... Remove the two bolts very carefully. Installing them back in is harder than removing them..
The hydraulic screen is straight down.. it has a wire that keeps it from un-screwing.. Like Stony jim said, make sure to put the wire back in.
To adjust the clutch, remove the plate uder the bell housing.. You will have a set of bolts with lock nuts on the back side of the pressure plate.. Un jam the lock nuts and turn each bolt one turn and lock down. Test to see if it is tight enough.. If not only turn them a half round if it needs to be tighter..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
