Posted by T.C. in Tx on September 02, 2008 at 07:14:51 from (66.69.214.239):
In Reply to: shop air lines posted by oj on September 01, 2008 at 17:50:16:
I went through the same "what to use" exercise two years ago for my shop. Of course all the naysayers advise strongly against PVC.
My final choice was PEX--the regular stuff because it was available at the local building supply superstore along with all the fittings I needed.
It has been in service for over two years now without a hitch. I would do it again. While I have not run a consistent pressure above 110 psi, I believe it is rated up to 180 psi depending on the temperature. Since I am in central Texas, sometimes it gets hot up there near the roof where I ran a line overhead to the opposite side of the shop. I put drops below the air outlets to be sure that condensation could be drained, but I have never experienced any problems with that.
I did find that the PEX that is used for heated floors, etc. is actually rated for air service. Good luck on your choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
