Seems to me that I remember cutting tobacco...you had a cutter and a spearpoint...you put the spearpoint on one end of the tobacco stick and stabbed the other end in the ground. You cut ten tobacco plants and used the point (sharp) to poke a hole in the stalk and slide them down on the stick. Then you removed the point and went to the next stick. Theres tobacco cutters and then theres tobacco cutters...some of those tough little thin built fellows would be to the end of their row and headed back before I got to the end of mine. When you got enough cut, you'd load it on a wagon and haul it to the barn and climb up in the top and stand on three inch poles to hang it. Another job for those thin built fellows. After it was all in the barn, it was Miller time...and believe me you needed it...that's a tough job...and you're not done yet cause next is to strip it when it is in case, I believe they call it. (I've never done this)Anyhow along about Christmas time they always took it to Ripley, Ohio or Maysville, Ky. to sell it. The brothers went along on this trip once and they took a fellow with them that seemed to me to be one fry short of a happy meal and as they went across the Ohio river he said "Goodbye old United States." Someone else who has raised it will probably add more to this...like sitting on the back of the tobacco planter and setting plants and it was something for me at 5 or 6 years old to look in the water tank and see crawdads in there. I never liked to sucker it though, breaking off the suckers so that the plant would put it's effort on the main leaves...that's enough...ohfred
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
