Posted by RodInNS on October 04, 2008 at 14:11:18 from (216.118.158.123):
In Reply to: Dualing Radial Tires posted by CircleMFarm on October 04, 2008 at 06:10:28:
It depends on the tires... I have a set of Firestone 23 degree radials on the inside and a set of GoodYear Dyna Torque II's (bias) on the outside. The DT II's are bigger, and bigger by a good amount. I run them like that but I let the air WAY down in the outside tires. As low as I dare, actually. It's not something I'd recomend for traction... and they ride..... basically like any other half worn DT II. Like crap! You'd be better off to get a new set of inside radials and throw the worn ones onto the duals if you can swing/justify it... That's what I plan on doing when the Firestone's get a little more wear on them.
I will also say that these are mounted on T-rail's and I've broken both rear wheel centers now. Mind you, it hauls heavy, on rough roads... fast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
