Posted by RAB on November 08, 2008 at 00:28:49 from (195.93.21.10):
In Reply to: Farmall M smoking! posted by Mayor on November 07, 2008 at 17:16:23:
Detergent or non-detergent oil?
rebuild..... well, if it just tuurns out to be stuck rings and you are sharp enough/clever enough/lucky enough to get them freed off without breaking them, put them back EXACTLY in the same place (ring gaps) as you removed them if they are still serviceable and bolt her back up. Remember they will be worn to the shape of the bore and turning them round may be bad news...
Non detergent oils were bad for gumming and varnishing rings. Rings can often be freed by soaking in a solvent plus heating and cooling cycles, without the need for prising them off with a screwdriver!! Some will pop free easily, some may need a couple hundred Celsius, or more.
If they are worn beyond service limits you will need to consider the bore wear (size and shape) to decide the best way to proceed.
Also remember if it has been stood for a long time, the exhaust valve(s) that was(were) left open may well be corroded and not seating properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.