|
Tractor Talk Discussion Board |
Re: Re: Continental F400A613716S
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Alberta Mike on March 28, 2000 at 18:35:57 from (207.153.51.115):
In Reply to: Re: Continental F400A613716S posted by mlr on March 28, 2000 at 07:36:40:
Yup, you're right about the little Continental flatheads (side valve). The F400 number was cast (not stamped) into the side of the engine block (with more numbers following) on all of the sizes you mentioned. It also showed up as the 163 cubic inch model you mentioned as well as a 135 cubic inch version. To my knowledge, they were all the same (with some variations in bore, etc.). They were also used on the MH 101 and 102 Jrs, the Case V's (not VA's) and on the Oliver 44's (not too many of those around). Maybe someone had a grandiose idea of dropping one into a Farmall but that would have been quite a job with the clutch housings, etc.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
