Posted by Shetland Sheepdog on November 13, 2008 at 15:56:20 from (72.71.233.124):
In Reply to: tractor discs posted by KEH on November 12, 2008 at 12:55:06:
Connie L said: (quoted from post at 17:16:28 11/13/08) I had it centered and it pulled left, so I put far left and it pulled left again. I'll recenter the frame and tighten the right swing arm chain. It's worth a try.
:) Hi, it's me again! Don't bother to center the hitch! I had a brain cramp!! :roll: I thought that it was pulling right! :oops: Instead of moving your hitch frame, change the gang angle. The front gang is cutting more agressivly than the back gang which is pushing it to the left! :o I think that if you hit a happy medium it should trail straight. Swing the right side back a little or the left side ahead so that both front and rear have the same angle of cut. Sorry about the bad info on the last post, hope that this works for you. :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
