Posted by NE IA on November 17, 2008 at 21:02:40 from (206.72.18.153):
In Reply to: pigeon problems posted by CbarJ in MO on November 17, 2008 at 11:57:49:
A bb gun / pellet gun makes it very easy to get them. The most important part of the gun is a add on lazer. Shine a flashlight at night till you spot the bird, then shut the light off and put the lazer red dot on the bird. You don't have to be a good aim as you need not shoulder the bb gun. You can shoot from a ladder, or shoot it off your hip. My sons and I used to do this often for farmers / friends. We always used the pump guns so you could use only as much power as you needed. Often we used a Co.2 cartridge if it was alot of birds. The birds will seldom if ever fly even with the red dot on them.
It seems to work better with two, one on the flashlight to spot the bird.
I would wonder if you purchased a bb gun and lazer for a neighbor kid on the condition it was his after all birds were gone?? Be sure to purchase saftey glasses. We always used saftey glasses and a cutting torch full face mask with a clear lens in it, as eye sight seems rather important in our lives, let alone a small boys. Our rule was any boy without both glasses and a mask on had no turn shooting, rather ended up holding the flashlight all night.
We did notice that the very cold winter nights, the birds were less likley to leave the building, especialy in a snow storm with lots of wind.
They also make a CB round for 22's that have very little powder, but extra expensive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.