Posted by ericlb on November 18, 2008 at 18:34:38 from (72.173.211.235):
In Reply to: O/T Wood chipper posted by 37chief on November 18, 2008 at 18:21:46:
if you have one of those old style non self feed types with that old industrial v8 on it from the '60's or '70's i can tell you ive fed one a log 8 inches in diameter by 15 feet long and it ate it without a wimper, and if your not real carefull it will eat you too im assuming if your thinning you have a lot of experience running chippers, if you do not that one is not the one to start out on , there is no safety reverse or emergency shut down on it, if a tree branch grabs you your dead, period, they work extreamly well but they stopped making them for a reason, [ ours self destructed, a bearing on the chipping drum froze up and the drum tore out of the machine and made a path thru the brush and saplings 200 yds long, we had no desire to try to get it going again either]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
