No, rod packing can not be replaced with O-rings. The rod packing, typically, is going to be a lip type seal. The most common type on the older machines was a multi piece Chevron type V packing and the "newer" stuff usually uses a single "polypack" type. Both use both the interference fit of the lip as well as the hydraulic pressure in the cylinder to force the lip against the rod causing it to seal. An O-ring has no way to provide the type of high pressure seal needed in this type of application.
As for the pits on the rod I can only say this without actually seeing it. I"ve seen new cylinders get dented, scratched, etc on their firs day on the job and have also seen cylinders with numerous pist, scratches, etc run alot of years with no real problems. True your gonna get "premature" wear on the seal and a bit of leakage but unless there is a massive amount of deep pits, scores, etc they probably aren"t worth worrying about. The worst thing you can have on a cylinder is a scratch running length wise of the rod or running around the circumference of the rod. The length wise one will let fluid run right under the seal and the other will allow the lip of the seal to drop into it so the movement of the rod pull"s at it, and eventually cuts it.
Like I said a number of small pits spread out over the length of the rod will allow minor amount of leakage over time and you won"t get the "full life" out of the seal but beyond that there"s no reason you can"t use a lightly pitted rod. If you want absolutely zero leakage then a new rod is your only choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.