Posted by Paul from MN on November 25, 2008 at 14:04:49 from (75.134.131.107):
In Reply to: Bad Ignition Switch??? posted by Bob Kirk on November 25, 2008 at 13:52:06:
The "gizmo" could be your problem. It is a ballast resistor that steps your voltage down from 12v to 6v, since the tractor was originally 6v. It allowed the tractor to keep the original 6v coil but use a 12v battery.
When you replaced the coil, did you get a 6v or 12v coil. If you put a 12v coil in place and left the resistor there that is your problem. You are still stepping the voltage down, but have a coil that needs 12v. When you hot wired the tractor my guess is you skipped right past the resistor. Either remove the resistor, or put in a 6v coil. If it was mine, I would remove the resistor and use a 12v coil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.