Posted by buickanddeere on November 27, 2008 at 06:04:23 from (192.75.48.150):
In Reply to: Carb ice posted by wallacedw on November 26, 2008 at 12:38:33:
You will have to either duct warm air to the carb inlet. Or maintain enough heat on the carb"s body to keep melting the ice. On airplanes when they talk about manifold heat. They are flipping a damper door and ducting intake air over the outside of the exhaust manifold. Before it"s drawn into the carb inlet. Hot intake air into an engine increases the tendency for detonation and therefore engine failure. The over rich mixture used on takeoff and initial climb reduces the tendency for detonation. Adding alcohol to the fuel makes the icing problem worse. The alcohol valorizes at a lower temp than gasoline.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
