Posted by John B. on November 29, 2008 at 05:58:47 from (38.114.64.185):
In Reply to: MOTOR STUCK posted by Darren T on November 25, 2008 at 23:04:14:
Go to your local army surplus store and buy some rifle bore cleaner. It works great and fast usually over night. I've heard about it and seen it work. I looked at a tractor a neighbor had sitting outside (w/exhaust covered) and tried to start it without any luck. Well a year later I bought it from him and pulled it home only to find out the engine had locked up in just 12 months. I tore it down and I couldn't believe how bad it had corroded inside. Tear yours down and work on one piston at a time they're easier to remove that way instead of trying to move all of them at one time by turning the engine over. Remember it's stuck and you'll have to tear it down in the future any way 9 times out of 10. The rings stick to the pistons and uses oil then. I bought an IH 574 the dealer said it needed a valve job. Well I figured I'd do it my self. Well when the head was pulled off I seen the pistons were scarred around the edges. Good thing I didn't run it very long before pulling the head. Could of cost me a bore job! Just do what you feel is right is what I tell people! One thing I keep in mind is a "Little education can broaden a narrow mind but there is no cure for a big head". If it's not done right why do it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.