Posted by Mr. Bob on December 19, 2008 at 19:22:15 from (71.186.13.241):
In Reply to: The Metric System posted by John B. on December 19, 2008 at 17:45:15:
To convert, say a chainsaw"s engine "cc"s" to cubic inches you multiply the "cc"s" by .061 and that will give you the cubic inches of the engine. ex. a Poulan "Wild tThing" has a42 cc engine. Multiply 42 x .o61 and you get 2.562 cubic inches. If an engine was a 4.3 liter for example; first move the decimal and get 4300 cc"s, then multiply by .061 and you"ll find you have a 262.3 cubic inch engine. Maybe useless info, but I like using it to make compairsons between engines which are now described by their metric displacements rather than by cubic inches as was widely used before. Mr. Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
