plasma cutter got me worse than any welder has. Just this last summer I worked a job where we were gutting a Chilis restaurant closed down. I used the plasma cutter to cut out all the stainless in the cooking line. It was hotter than heck that day so the goggles came off after about 20 minutes. I bet I cut on that thing for about 5 hours. Then loaded a 26 foot Rental truck with used restaurant equip and headed out for Sandusky Ohio, for another restaurant that was buying the used equip. I had convinced myself my eyes were bugging me just because I was tired. Well by the time I drove from Grand Rapids to Howell, i was crying so bad i had to stop for an hour. After the hour break I cried my way to Dundee and grabbed a hotel for the night. Oh my goodness, I was in so much pain the next day, but I some how managed to make it to Sandusky by 8 the next morning and back to GR before I coulkd finally give my eyes a rest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
