Posted by trucker40 on December 22, 2008 at 17:48:43 from (69.154.17.105):
In Reply to: broken bolt posted by Roy in georgia on December 22, 2008 at 16:40:58:
Drill a hole all the way through the bolt in the center of the bolt.Might want to start with a small bit and work your way up.Once you get it most of the way way drilled out if its big enough that a welding rod will go down in it,weld it on the inside out with a nut on top.Weld the nut good and let it cool off.Maybe just go get a cup of coffee or something and take a 10 minute break.Squirt it with penetrating oil.If you are lucky it will shrink a little and you can screw it out.OR keep drilling until all thats still in there are threads and pick them out,or drill it out with helicoil bit for that size hole and install heli coil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
