Ours was coal fired. It had a box about 15 inches square, and 18 inchs deep that was the fire box. It had a removable for cleaning, grate about 3" off the bottom, made from iron rods about 5/8 diameter, spaced abput 3/4" apart. A 3" diameter inlet pipe was J shaped and about 10 inches taller than the top of the box. The "chimney" was 6" and ran for about 3 feet under water to heat additional water with flue heat before turning up to the vertical, and stood 5 or 6' above the box, and was on the opposite side from the intake. All these were iron/steel and sealed to prevent water from getting in. The lid was hinged to allow loading and tending, but was overhanging to limit cattle from splashing water into the joint. A damper was set into the exhaust pipe to regulate draft. I would put it into both intake and exhaust to regulate combustion more easily. Both had cone shaped "hats to keep out rain. It was set into the tank with about 2 inches of wall above waterline. This is a memory from more than50 years, so take it for that!! JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
