But, here goes: I would recommend she travel West to San Antonio and see the Alamo and River Walk and then travel North to Austin and see the State Capitol and some of the old Spanish Missions that are still in the area. There is also a lot of Tourist stuff between the two cities.
From there, I would go North to Waco and see the Texas Rangers Museum. She can then return back to Houston or go A little further North on I35W and see the FortWorth Stockyards (the Ft. Worth Zoo is excellent also).
Then go East on I30 to Dallas and see the down town area where the Kennedy Memorial is and the West End area (the Dallas Aqarium is Excellent also).
Then she can head strait back to Houston on I45 South. She will thru the Woodlands, which is very scenic. While in the Houston area she may want to see the NASA area and go South to see Galveston Moody Gardens. However, the area is still tore up from the Hurricane so she may not want to see the destruction. Moody Gardens is a neat destination.
You can do a search for each of the areas listed and see what each has to offer as additional tourist locations.
The whole trip will be somewhere around 700-800 miles and will give her a good view of the diverse landscape of Texas: Hill Country, Plains, Piney Woods and the Gulf Coast. The only parts she would miss would be the High Plains area out in West Texas. That may be a bit far for 1 week.
If she planned 1 major area per day she could see all of this and only drive 150-200 per day. Book in good hotels and she should be in decent areas and reasonably safe. Good Luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
