Posted by brian ridgway on January 11, 2009 at 18:12:03 from (173.20.34.208):
In Reply to: Re: '67 706 cutting out posted by the tractor vet on January 11, 2009 at 11:50:39:
engine has been bored out to a 301 in one of your previous posting i read the low ash oil and 93 octane so i followed your advice so thats not the problem. I havent messed with this tractor since september, but when it was warm outside i let it warm up one day for and hour and a half. that was back when gas was 350 a gallon. so that was not cheap but i knew it had to be done to get all the bugs work out. My uncle in law runs a 460 with a 301 in it for his plling tractor so the timimng is set right. you are the guy i was fishing to find on this cite. do you think it is the carburater. should i send it off or rebuild it myself, did i mention the electronic fuel shutoff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
