Posted by glennster on January 24, 2009 at 20:12:38 from (68.60.242.156):
In Reply to: Ear corn auger posted by rrlund on January 24, 2009 at 08:18:24:
rrlund, i been thinking about that powered auger taht we used. ours was a single auger, not a double. i remember running it, had a centrifugal belt clutch on the engine to a gear reduction box. the auger turned real slow, tires were about the size of a riding mower back tire, you roll up to the crib, start er up, throttle up, the auger would pull itself into the crib, hit the two iron stops, and then start pulling ears out. auger was pinned to the gearbox with a shear bolt in case it hung up. if my memory still serves, seemed like the gearbox shaft was about a foot long, betwen 7/8 to an inch in diameter. the auger slid on to the shaft and you pinned it with a bolt. hope that helps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
