Posted by John T on February 13, 2009 at 17:15:30 from (98.115.40.108):
In Reply to: OT - GFCI posted by dr darren on February 13, 2009 at 15:52:22:
Doc,
1 - should there, or can there be 2 GFCI outlets on teh same circuit.
SURE You can have 2 or more GFCI outlets (just like any other regular outlets) on the same branch circuit.....THE QUESTION IS are they (later outlets) wired independant ORRRRRR is the downstream outlet still protected??????
Often one GFCI is wired while others downstream that ARE NOT GFCI (just regular duplex outlets) can still be protected. HOWEVER its also possible for the ones downtream to be independant and NOT trip out unless the branch circuit breaker in the panel trips
2 - one GFCI is popping all the time and all that is plugged into it is the .5 watt night light, but that night light is always on. why would it pop?
The GFCI pops if theres like 5 millimaps less Neutral return current then the current going out the hot Line.......Theres a Torroidal coil around BOTH the hot and Neutral but if the line current is equal to the return Neutral current the net is zero and no voltage is induced in the coil and the trip out mechanism doesnt function
PRACTICAL ANSWER: if BOTH receptacles are GFCI types I WOULD wire them both hot so one or the other can still function independantly.....
Tnere may be a lil diagram on the GFCI indicating which sets of wiring terminals to use, ITS NOT ROCKET SCIENCE they will show where to wire the source (branch circuit from panel) and downstream. Basically to be wired independant (both work on their own) the hot wire to the second downstream outlet (be it GFI or regular) is spliced so it stays hot regardless if the first GFI trips out ......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.