Posted by JMS/.MN on March 03, 2009 at 07:37:41 from (209.237.107.155):
In Reply to: Re: allis chalmers posted by rusted nuts on February 28, 2009 at 18:59:08:
I"d take out the shaft that the crank fits on, and replace it with a shaft coupled to the original pulley. Is there a D17 in the area you could look at? Kind of tough to see, but the pulley has a machined front, with 4 holes drilled and tapped. A flat plate bolts to that, and the plate has a shaft on it that runs forward through the steering box, and the front of the box is machined and tapped to bolt a pump on to. I"d do the same with the WD. I don"t know if the WD crankshaft is the same diameter as the D17- if it was, the D17 pulley should fit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
