dtv is from only channels 2 through 51. 52 through 69 are disappearing for the same reasons channels 70 through 83 and previously channels 84 through 114. Channels 2 through 6, 54 to 88Mhz are going to be mostly ignored by dtv. They are low frequency and require the long/wide elements on an antenna.They suffer interference from the FM radio broadcast bands and vice versa. Channels 7 through 13 are 174 to 225 Mhz. Channels 14 and up start on the upper side of the 470Mhz Ham and and two way radio bands. The so called "dtv" is usually built without the specific long elements for channels 2-6. This causes no loss on channels 7-52 and cuts the antenna width by 2/3 and reduces the length by half. My antenna has no elements for channels 2-6 but receives them just well as the old antenna. The TV signal maybe weaker but the amount of FM radio interference has also been reduced.It's about a draw on performance. The advantage is a much smaller antenna that doesn't wind load the tower and rotor as much. The main problems are old crummy RG-59 coax, no antenna amp, no rotor and a poorly designed/poorly constructed dtv converter box.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
