Posted by 37 chief on March 23, 2009 at 19:20:22 from (70.181.173.198):
In Reply to: Truck Brakes/No petal posted by J. Schwiebert on March 23, 2009 at 17:25:14:
My chevy 6400 series truck had tha same problem. I would power bleed the system and have good brakes for one day, maybe two, then it would just get no peddle again, I replaced all wheel cylinders, had the master cylinder sleeved. same problem. Now here is what my problem was. The hydrovac unit was leaking internally, sucking brake fluid into the motor through the vac line. I could never figure why my master cylinder kept going down, and could see no leaks.To check this remove the vacuum fitting at the hydrovac and see if it is wet inside. There should be no wetness. My rebuilt hydrovac unit cost 160.00, Let us know what you found. stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
