They WILL bolt to the wheels on the BLUE tractors!!! We used them on pressed steel discs, but they would go on cast discs also! That's the reason for the flat place in the center hole, to clear the clamps on the bar axle! I am including a picture of the wheel on my 5610 with 18.4 x 30 tires, you will see 3 square holes in the disc at 12, 4 & 8 oclock. those weights should bolt on using those holes! I will agree that the weights are NOT the ONLY weights made for Fords, there are also larger diameter weights for the larger wheels, but I think that you will find that the bolt pattern is the same on both style weights!
Dave 8)
One other thought, Those weights will probably NOT work on 9, 2 & 8N's or NAA's because the discs are not equiped with holes to attach them. The pie weights attach to a disc bolted to the tractor with special lug bolts that hold the wheel on AND have a provision for the original lug bolts to thread into them to secure the pie weight disc! ( I had a set of pie weights on a '72 3000).
This post was edited by Shetland Sheepdog at 10:44:31 04/20/09 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
