Posted by s.crum on April 26, 2009 at 05:07:31 from (4.156.231.230):
In Reply to: Clockwise or CCW posted by chuck craig in sunny soca on April 25, 2009 at 22:46:04:
Pretty rare to find a gas engine that turns CCW. The general standard for engine rotation is the engine is veiwed looking at the 'front' or water pump end. The flywheel end is the 'rear'. Fans can be confusing as to push or pull on industrial equipment. I have a Hobart G-3010 engine drive welder with a Chrysler 225 slant 6 engine. The rotation is obviously CW and the fan pushes the air out thru the radiator. Presumably this is done to pull cool air in thru the rear of the unit over the generator sets then the engine. On a rear engine grader it's likely done to force the hot air out the back away from the operator station.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
