Posted by ScottyHOMEy on April 27, 2009 at 14:58:04 from (70.105.254.131):
In Reply to: more trivia posted by ken in texas on April 27, 2009 at 13:53:03:
Most gudgeons the pin that goes through them is known as a pintle. A gudgeon is to a pintle as a mortise is to a tenon.
More common usage on this side of the tall water is nautical. On tiller boats, the pintles are the hinge pins that provide the support and pivot points for a rudder. The gudgeons are the fittings on the rudder blade that fit over the pintles, and also slip back off for stowing the tiller and rudder.
For a more trivial reference at least to the gudgeon or, more precisely, the pintle that goes with it, we can go to the old Robert Burns poem, later put to music called, "Nine Inch Will Please A Lady."
Written from a woman's perspective, it allows (translated from Scots to English) as how, "We'll take two thumb-breadths to the nine, and that's a sonsy pintle." Not sure how to translate sonsy, but you get the picture.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
