I looked at Pat's website and that is for severely damaged concrete. Most spalling I see from salt/snow melt usually only has pitting that is a 1/4" to 1/2" deep at the most. Not deep enough to skim coat any concrete or cement mix and expect it to stay. I suppose there is some type of liquid acryllic stuff you could try to trowel on. Probably a waste since it won't stay either but something to think about if you are a good troweler. If it already looks bad then what the heck except that stuff is usually a dark grey color and may look worse when it peels off.
If you tear it out and start over or if you top coat it with 2" of concrete, the trick is to get the right kind of mix and then float it and trowel it just right to avoid spalling the next time. Your concrete company can probably tell you as I can't think of the best mix off the top of my head. Same of the methods of floating and troweling, you need to get the rock and fines in the right place with some but not too much cream on top. It's been a while for me but a regular concrete finisher here will tell you. Maybe a finish spray and keeping it covered and wet in the hot sun will help cause part of the problem is how the concrete cured also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.