Tractor Talk Discussion Board |
Re: Are Narrow fronts with Loaders always dangerous?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom from Ontario on September 24, 2000 at 18:05:28 from (216.129.12.62):
In Reply to: Are Narrow fronts with Loaders always dangerous? posted by MT Greenhorn on September 24, 2000 at 10:52:47:
I loaded semi-solid hog manure for years with a D-17 narrow front and the loader was a 417 A-C with a seven foot snow bucket. It was tippy on flat concrete. We changed to doing a bit more field work with the tractor including moving stooked hay and flat-8's. The narrow front end was impossible as our land rolls a bit and we were lifting as high as we could go. We put a wide front end under it. We gave up a LOT of maneuverability, but got stability and safety. We also put heavier wheels on it where we had to run standard rims on the narrow front ends and smashed three or four per year. The other fellows here are dead on. Think safety and you'll do fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|