Posted by Billy NY on May 22, 2009 at 06:38:19 from (74.67.3.238):
In Reply to: Re: Concrete repair posted by fregienewbee on May 22, 2009 at 05:25:51:
I think if you were to use straight portland cement, it might be too brittle when hydrated/cured, it will bond, but I believe it really needs to be part of a material mix design, like a mortar, concrete, grout etc. You need the aggregate and other composite materials of different sieve sizes to achieve thickness, I don't recall ever seeing straight up portland used for parging. It's a fine particulate material, like dust, would make a slurry with too much water, will sag off, and may not work well if mixed up stiff too, (less water) Mortar if applied too thick can also sag and will come off, need to have that mesh and or a material suited for this to achieve good results, as I see it, could be wrong too though !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
