Summer of '59 we put up a bunch of "local" hay (dad couldn't afford alfalfa that year, after the disastrous milk prices in '58) with a Dearborn sickle bar mower on an 8N Ford, then tag-along side delivery rake, then baled with a Case hand-tie baler. Cousin Fred drove the 8N, Dad "shoved the needle"- double channel units that were pushed through the bale with a spring-assisted handle, then wires threaded through. I tied the bales, riding on a seat right behind the hay pickup on right hand side. Cousin Jim walked along with a pitchfork to push hay into the chamber if the going got heavy, because all it had was a wide belt to carry hay in, no auger or fingers. I was 10, cousins were about 12 and 13. I drove the truck (International one ton, about '45 vintage) in the hayfield, because I was too little to buck bales. Many thousands of bales, went well into August, and the hay was pretty much straw by then. That was the beginning of the end for the dairy operation- hay was so poor the cows all but dried up that winter, and they got sold in the summer of '61. In retrospect, Dad said "I always wanted to farm in the worst way, and I expect we pretty much did."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
