Finding TDC on the marks on the damper is different that using a positive stop to find TRUE TDC. And I only threw that tidbit in because you want your point of reference--TDC, in this case--to be accurate, in order that your conclusions about the problem will also be accurate. If TDC on your damper is 20 degrees off from true TDC, using the damper-indicated TDC mark for a reference point will ALWAYS result in inaccurate results.
And most of us know that, at TDC, BOTH the intake and exhaust valves for that cylinder should be closed. ANY other outcome is evidence that the engine is out of time [cam timing, as opposed to ignition timing]. While radical cams that cause "rumpy-rump" idling will have more overlap than a stock cam, by TDC even the most radical cam should have both valves closed.
As far as using a dial indicator and a degree wheel to determine whether the intake valve is opening where it should, unless you have the manufacturers' spec for that particular camshaft, you're only guessing. Even if the engine is "stock," the 289 hi-po [271 HP] engine used a different cam than the standard 289...so without knowing exactly what cam is in the engine, you're just urinating in the wind.
And using a degree wheel and a dial indicator is basically useless, if the timing chain and gears are suspect...primarily because the results may not be repeatable on a consistent basis. Sounds like you've read a HOT ROD or CAR CRAFT magazine sometime in your life, but only vaguely understood the subject matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.