Not likely cam timing of the problem comes and goes. What the guys say about sticky / worn ignition parts sounds likely.
Thought I would share the goofy situation I ran into on a relatives 302 Maverick.
He had that short lived aluminum / nylon cam sprocket that shed all the nylon and slipped the chain retarding the cam. He replaced the timing set and could hardly get it to run, hard to start and would stall at low rpm. I told him he had to have installed the new timing set 1 tooth retarded, because thats exactly how they run with late cam timing. He absolutly swore he had double checked it and the marks did line up. I thought "yeah right" and tore the front of the engine down in my shop. THE MARKS WERE LINED UP!!!, but something about that new cam sprocket looked odd. Normally on a SB Ford cam sprocket you can draw a line from the center of the sprocket, through the dowl pin to the mark on the edge of the sprocket. On this one, the line through the sprocket center and dowl hole missed the mark by 1 tooth !! The guy who drilled the dowl hole at the factory got it 1 tooth off in the drilling jig !!. Other than that, the sprocket was perfect, so after comparing another old Ford cam sprocket to make sure I was right about the cam,dowl pin and crank all being in the same line, I reinstalled the misdrilled new sprocket 1 tooth off from the indicated mark. It ran perfectly, ran that way until it wore the car out. Normally a guy doesn't think to look for crap like that, but it did happen, atleast once. :0)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.