About 25 years ago in the factory where I worked we had the 2" metal flexible coupling blow off of a 1000 psi compressor. I was standing within 6' of it and it blew carbon bits in my arm, eyes and one side of my face. The doctor scrubbed my face raw with a brush to get the materials out. He told me later that he had people to hold me down so that he could scrub as much as he could on the first try because it is so painful. To remove the particles in my eyes I had to look straight ahead while the doctor drilled just through the surface of the eye and popped the particles out. I still have a little bit left in there. The compressor was one that was moved from a different location and piped in by the 2nd shift. We wired it up and our foreman even checked the piping out but somehow missed the fact that the relief valve and the pressure switch were not located in the right place. It simply ran until it blew the coupling off. Another piece of high pressure pipe hit the wall about 30' away in another direction. That was the loudest noise that I ever heard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
