I did this with a Howse 5' hog about 12 years ago. I diden't have a tractor with 3 pt and only had a JD AR to pull it. I welded 2 pieces of 1.5" X 1/4" angle into a square and connected it to the existing slide tube. I also used a rear axle from a Dodge Omni for the trailing wheels. I took a guess from other trailers I'd seen, and made the slide shaft stop just behind the hitch. By the time I hooked it up to the PTO, there was a foot of sliding area for the shaft.
PTO shaft placement on older tractors varies in height and distance from drawbar
I have to repair my brush hog since climbing out of a low ditch, the hog bit into the ground and the AR (unphased by this, and thumping away)ripped 1/2 the teeth off the pinion gear, so good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
