Posted by buickanddeere on July 05, 2009 at 20:23:15 from (216.183.138.109):
In Reply to: Re: smoking 2n posted by Ultradog MN on July 05, 2009 at 19:28:31:
Most people seem to understand how limited the Allis Bs or JD Bs or the old Masseys or Cases or Cockshutts with no hydraulics or lift of any sort? The Farmall Hs too or the JD H's are. Too many people, perhaps due to their appearance. Seem to mistake the N series for something more capable. Most of the small tractors of that era were best used as a direct substitute for a team of horses. And were connected to horse drawn equipment with shortened hitches. Doesn't matter what brand it is. Going out there to bushhog without live pto, without an over running clutch and without live hydraulics. Manual steering that kicks back with marginal brakes at best.Is just looking for trouble. If somebody is pushing the $$$ limits that close to the edge that the difference between an N series and a 800/later series/Massey 35 etc. Is going to finish them off. They are akin to being in water over their chins. One little slip and they drown. Better to stay back in the waist to chest deep water at most. "Getting in over your head". Those old time machines have their historical value. And have some use in a few applications today. The mistake is people who should or don't know any better. In trying to make these limited old machines do something they can't.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
