Basic timing is set by the computer itself - so no matter if you turn the distributor 5 degrees one way or the other, the computer will compensate for this change in timing. Look closely at the rotor - it's pretty wide on the end. All the computer cares about is that there be a certain degree range of contact between the end of the rotor and any one plug terminal in the cap.
I've just done an analysis of a 4.0L AMC engine by compensating an aftermarket camshaft gear to its original distributor. The distributor (non-adjustable timing) had to be mounted 25 degrees CW in order to function to this new camshaft (AT NO. 1 TDC). As for TIMING the 4.0L engine - the computer takes care of this, and NO AMOUNT OF FIDDLING WITH IT WILL ALTER ENGINE TIMING.
Just as long as that rotor is DEAD on the NUMBER 1 CYLINDER AT TDC, the computer will handle this timing ITSELF. It also controls advance and retard based on environmental and other physical conditions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
