Posted by LouNY on July 16, 2009 at 17:29:58 from (204.13.145.109):
In Reply to: Re: tragic accident posted by caseihman94 on July 16, 2009 at 08:07:55:
I just love how all the safety POLICE crawl out of the woodwork when a kid gets hurt. No body wants a kid to get hurt and I would and will not let a kid ride when I am brush hogging, but when I am doing other chores I most certainly will. If they are not up on the fender how in the hell can they learn how to run tractors and equipment.The operator has to be carefull but whats new. I learned to drive on a WD picking rocks and driving while hay was being loaded. Steep hills side slopes and this while I was so young that I had to throw the hand clutch and the swing around and stand on the brakes. I could not count the number of hours that I have spent on fenders, and much more hazardous spots such as the drawbars. So while I am sorry when most anyone gets hurt on equipment, growup, pay attention, work safe and becarefull all the time but especially when training anyone how to use tractors and implements
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
