Posted by LOU from WI on July 22, 2009 at 21:16:40 from (174.124.85.37):
With no equiptment to speak of. but a circular saw.press,mig welder. arc welder,limited hand tools and a whole lot of patience,it is more then possible to close in the floor so no wind, snow comes in to freeze the operator. Floor material is 16 guage with flanges that fit into the existing floor plate.The battery is set into the panel on the right side.and will be herculined so the battery will not be able to rub on the panel,and no gas from the battery will destroy the panel. The panels are notched to fit around the brake pedals and clutch. There will be 8"X16" boots over all the pedal arms. Thought you folks would enjoy the pictures and the 706 is comming together. More work tomorrow. LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
